; UMBRAPHILE DATA FILE FOR 01 AUG 2008 TOTAL SOLAR ECLIPSE
; FOR UMBRAPHILE X (and 2006 B)
; For an explanation see:  http://nicmosis.as.arizona.edu:8000/
;   
SOURCE  = 'USNOAA'   ; Must be 'USNOAA' or 'NASARP'
DTYPE   = 'TRIG'     ; Must be 'TRIG' or 'DIRECT'
;
; POLYNOMICAL COEFFICIENTS AND ELEMENTS FOR FOR COMPUTING BESSELIAN ELEMENTS
;
Range    =  -0.042, 4.808  ; Range in TDT for valid coefficients
T0       =   8             ; Base time for series expansion
DELTAT   =  -0.37381       ; Delta-T in seconds (0 if U.T. elements*) 
XCOEF    =  -0.94591516,   0.52873318   -0.00001517, -0.00000812
YCOEF    =   1.25129252,  -0.20188452,  -0.00017084,  0.00000330
SINDCOEF =   0.30715039,  -0.00016771,  -0.00000014,  0.00000001
COSDCOEF =   0.95166098,   0.00005419,   0.00000000,  0.00000000    
; DCOEF  =   0.00000000,   0.00000000,   0.00000000,  0.00000000
MUCOEF   = 298.42103964,  15.00200439,   0.00000199, -0.00000001, -0.00417807
l1COEF   =   0.53798726,   0.00015867,  -0.00001199,  0.00000000 ; Umbra
l2COEF   =  -0.00835641,   0.00015808,  -0.00001201,  0.00000001 ; Penumbra
tanf1    =   0.004607     ; Umbral Shadow  
tanf2    =   0.004584     ; Penumbral Shadow
SD       =   17, 51, 56.5 ; Solar Declination at Mid-Eclipse
MUP      =   0.261834     ; Time derivative of MU in radians/hour
;
; Notes:  (1) Delta-T = +66.0 seconds is "built-in" to these polynomial
;         representations of the Besselian elements.  For a different value
;         of absolute Delta-T set DELTAT = Delta-T minus 66.0.
;         (2) A correction of (+0.50", - 0.25") has been applied to the
;         latitude and longitude of the moon to compensate for the
;         displacement of the mean center of figure from the dynamical
;         center of mass.
;
; ANCILLARY INFORMATION
; UT of Mid-Eclipse (geocentric conjunction) = 10h 21m 08.1s
; 
; SPECIAL PATCHES FOR AIRCRAFT: 
DURADJUST = 1.000
;
; CAMERA CONTROLLER PARAMETERS
NUMEXP   =  36     ; Number of Exposures (*MUST* be even)
MAXEXP   =   0.25   ; Maximum Exposure Time (seconds)
MINEXP   =   0.01 ; Minimum Exposure Time (seconds)
ALARM    =  20     ; Time For Audio Alarm Before CII (seconds; min = 10)
MAXDCYC  = 100     ; Maximum Solenoid Duty Cycle - Warn if exceeded
; Note: Set MAXDCYC = 100 to always supress warning
;
; ELECTRONIC CAMERA SETUP AND CALIBRATION PARAMETERS (eg. Pentaz ZX-50)
ZEROEXP  =   0.010 ; Send an exposure 1s before first to initialize camera shutter
PREPULSE =   0.010 ; Duration of Pre-exposure Shutter Conditioning Pulse
DELPULSE =   0.050 ; Delay time between Shutter Conditioning Pulse and Open
MINRESP  =   0.015 ; Minimum Response Time
MINCMD   =   0.053 ; Minimum Reliable Command Time
CAMERCAL = -119.09, 1.0062, 0.00065224, -0.000000545 ; Camera calibration curve
;
; DIAMOND RING/CONTACT II+III PARAMETERS
CIIOFF   =  -1.8   ; Contact II offset from smooth dynamical limb
CIIIOFF  =  -2.5   ; Contact III offset from smooth dynamical limb
DRNUM    =   3     ; Number of CII and CIII Diamond Ring Exposures 
DREXP    =   0.01  ; Duration (seconds) for Diamond Ring Exposures
DRSEQII  =  -6, -4, -2 ; Delta-Times for DREXP Relative to CII
DRSEQIII =   6,  4,  2 ; Delta-Times for DREXP Relative to CIII 



